A new description for dispersion

Chang and Slattery (1986) introduced a simplified model for dispersion that contains only two empirical parameters, both of which can be determined in one-dimensional experiments. The traditional model for dispersion (Nikolaevskii, 1959; Scheidegger, 1961; de Josselin de Jong and Bossen, 1961; Bear, 1961a; Peaceman, 1966; Bear, 1972) has three empirical parameters, two of which can be measured in one-dimensional experiments while the third, the transverse dispersivity, must be measured in experiments in which a two-dimensional concentration profile develops. For the common one-dimensional experiment in which the signs of the concentration gradient and of the velocity field are different, the simplified model and the traditional model give identical results. For a one-dimensional experiment in which the signs of the concentration gradient and of the velocity field are at least sometimes the same and for two- and three-dimensional flows, the simplified model of Chang and Slattery (1986) gives results that can differ from those predicted using the traditional model.Only the experimental data of Bear (1961b) and of Yule and Gardner (1978) are sufficiently complete to permit a comparison of the two models. Considering the quality of the experimental data, we can not distinguish between the predicted profiles based upon the simplified model and those based upon the traditional model.     

小间距隧道爆破开挖动力效应数值模拟研究

从爆破施工的特点入手，对小间距隧道在采用典型双侧导坑法时的爆破施工动力效应进行了数值模拟研究，给出了爆破施工在已有洞室周边产生的动力效应的一般规律，指出在爆破（后开挖洞室）开挖影响区以内，合理确定已有洞室二次衬砌施作时间的重要性，并给出了爆破施工对已有洞室稳定性影响较大的关键开挖位置。研究表明，爆破动载荷对小间距隧道围岩稳定性的影响主要表现为爆炸应力波造成围岩临空面的反射拉伸破坏，破坏较严重的是已有洞室的迎爆墙、拱脚、拱顶等部位。所得结论对小间距隧道爆破施工有一定的参考价值。     

雷诺应力对平均和脉动压力影响的数值模拟

采用增加雷诺应力边界条件方法考察了雷诺应力对流场的影响。当雷诺应力边界条件存在时,流场内平均和脉动压力的变化体现了雷诺应力的影响。本文首先在没有雷诺应力边界条件和有雷诺应力边界条件的情况下得到TTU低矮建筑标准模型表面的平均压力系数,结果表明:考虑雷诺应力可使建筑物表面的平均压力系数的绝对值增大。本文还利用Selvam提出的脉动压力系数数学模型,计算了TTU模型表面的脉动压力系数,并对计算结果进行了分析。     

A study on the correlation between the thermal contact conductance and effective factors in fin–tube heat exchangers with 9.52 mm tube

The thermal contact resistance is a principal parameter interfering with heat transfer in a fin–tube heat exchanger. However, the thermal contact resistance in the interface between tubes and fins has not been clearly investigated. The objective of the present study is to examine the thermal contact conductance for various fin–tube heat exchangers with tube diameter of 9.52 mm and to find a correlation between the thermal contact conductance and effective factors such as expansion ratio, fin type, fin spacing and hydrophilic coating. In this study, experiments have been conducted only to measure heat transfer rate between hot and cold water. To minimize heat loss to the ambient air by the natural convection fin–tube heat exchangers have been placed in an insulated vacuum chamber. Also, a numerical scheme has been employed to calculate the thermal contact conductance with the experimental data. As a result, a new correlation including the influences of expansion ratio, slit of fin and fin coating has been introduced, and the portion of each thermal resistance has been estimated in the fin–tube heat exchangers with 9.52 mm tube.     

一种直流力矩电机系统的滞滑摩擦补偿方法

陀螺漂移测试转台直流力矩电机系统中存在的非线性滞滑摩擦，使转台在PID控制下存在滞滑极限环。为提高转台定位精度，应用具有滞滑(stick-slip)摩擦的直流力矩电机系统模型，推导了一种补偿方法，对含有滞滑摩擦的PID控制转台直流力矩电机伺服系统进行滞滑摩擦补偿。在采用PID控制的转台电机系统定位工作状态下，这种滞滑补偿方法可以减小滞滑极限环的幅值。仿真结果证明了该补偿方法的有效性。     

冷藏陈列柜相变蓄冷搁架的强化传热特性研究

为了降低冷藏陈列柜在融霜过程中食品温度的上升和改善柜内温度场分布,设计了带有相变蓄冷材料的热管型搁架,研究其传热性能。结果发现:热管改善了蓄冷搁架前后方向的传热性能,但左右两侧温度分布不均匀。针对此问题提出了在蓄冷搁架内添加肋片进行强化传热,研究结果表明:在蓄冷搁架中添加肋片可以使搁架温度场均匀性得到改善,显著提高蓄冷搁架的蓄冷速率。     

光阑对偏振高斯-谢尔模型光束偏振特性的影响（英文）

根据广义惠更斯-菲涅尔原理和Collins公式,基于复高斯函数展开法,推导出椭圆偏振的高斯-谢尔模型光束经过矩形光阑衍射后的交叉谱密度公式,结合斯托克斯矢量理论推导了椭圆偏振高斯-谢尔模型光束在接收平面的光强、偏振度、方位角和椭圆度的表达式,数值分析了光阑的孔径遮拦比对光强、偏振度及方位角和椭圆度的影响.结果表明,光阑的孔径遮拦比在近场区对经过光阑后椭圆偏振高斯-谢尔模型光束的光强和偏振特性有显著影响;随着传输距离的增大,光强和偏振特性受孔径遮拦比的影响减小,光强和偏振特性变化平稳.     

基于CCD对高斯光束进行实时判断及特性参数的测量

主要使用等距四点采光测量法,用CCD进行采样,电脑编程处理来判断、分析和研究高斯光束的光强在空间的分布情况——传播特性。并利用计算机可以实时判断激光器输出是否为高斯光束,如是高斯光束,还可以实验测得高斯光束的径向强度分布、束径以及扩散角。